URGENT · SAME-WEEK RESPONSE

Pool equipment repair in Bay Area, CA

Pool equipment in Bay Area works hard. Pumps log long hours, filters load faster, heaters cycle constantly, and salt cells age. Typical equipment lifespans: pump 5 to 8 years, filter media 5 to 7 years for sand, 7 to 10 for DE, 2 to 5 for cartridge. Salt cells 3 to 5 years. Heaters 8 to 12 years.

Bay Area · San Francisco Bay Area Coverage

WETYR Pools and our network of vendors

Bay Area and all of San Francisco Bay Area, CA

WETYR Pools and our vetted network of local San Francisco Bay Area vendors deliver pool service, repair, equipment, chemistry, and green-to-clean recovery across Bay Area, Palo Alto, Atherton, Los Altos Hills, Walnut Creek, and the wider San Francisco Bay Area area. Request a free quote and WETYR Pools dispatches the right local vendor for your job.

Request a Free Quote Email [email protected]

Pool equipment in Bay Area works hard. Pumps log long hours, filters load faster, heaters cycle constantly, and salt cells age. Typical equipment lifespans: pump 5 to 8 years, filter media 5 to 7 years for sand, 7 to 10 for DE, 2 to 5 for cartridge. Salt cells 3 to 5 years. Heaters 8 to 12 years.

WETYR Pools and our vendor network repair and replace all major equipment categories across Bay Area and San Francisco Bay Area. Request a quote on this page. For full equipment package upgrades or design-build, WETYR Pools delivers across the same footprint.

Step-by-step

Step 1: Diagnose the symptom precisely

Pump not priming = air leak or seal failure. Pump running but no flow = impeller clog or cavitation. Filter pressure spike = needs backwash or media replacement. Heater not firing = ignition, gas valve, or pressure switch. Salt cell low output = cell needs cleaning or replacement.

Step 2: Check the easy stuff first

Skimmer basket full? Pump basket full? Water level below skimmer? Breaker tripped? Timer set correctly? About a third of 'equipment failures' are one of these five.

Step 3: Request WETYR Pools for repair or replacement

WETYR Pools dispatches the right local vendor for the diagnosis and repair. WETYR recommends equipment upgrades when repair cost approaches replacement cost (typically at 50 to 60 percent of new).

Typical Bay Area costs

  • Diagnostic visit (Bay Area): $85 to $150
  • Pump motor replacement (single-speed): $400 to $700 parts and labor
  • Pump motor replacement (variable-speed): $1,200 to $3,000 installed
  • Pump shaft seal: $150 to $400
  • Filter cartridge replacement (full set): $150 to $500
  • Sand filter media replacement: $200 to $400
  • DE filter grid replacement: $400 to $800
  • Heater module replacement: $600 to $2,500
  • Salt cell replacement: $400 to $1,200
  • Pool light bulb (LED): $100 to $400 installed
  • Automation panel (Pentair/Hayward/Jandy): $1,500 to $5,000+
Verified WETYR Pools customers

What Bay Area pool owners say

Bay Area, San Francisco Bay Area, CA

WETYR Pools serves Bay Area and San Francisco Bay Area

Request a free quote and WETYR Pools dispatches the right local vendor from our San Francisco Bay Area network.